small electrical machine specifications

Machine Specification

ITEM			EC40N			EC60N			EC75N			EC100N				EC160N				EC220N
Injection Unit Code			i1			i1.5			i2			i2				i4				i6
Screw Diameter		mm	22	25	28	25	28	32	28	32	36	28	32		36	36	40		45	40	45		50
Injection Weight	PS	g	35	45	57	51	63	83	72	94	120	72	94		120	145	180		230	208	263		325
	PE	g	28	36	45	40	50	66	57	75	95	57	75		95	115	145		185	165	209		258
Injection Pressure		MPa	253	196	156	245	196	150	256	196	154	256	196		154	242	196		154	248	196		159
		kg/cm²	2580	2000	1590	2500	2000	1530	2610	2000	1570	2610	2000		1570	2460	2000		1580	2530	2000		1620
Injection speed		mm/s	200			200			200			200				180				160
Injection speed (High speed)*		mm/s	300			300			300			300				270				240
Plasticizing Capacity	PS	kg/h	22	28	35	25	35	45	25	35	45	40	61		83	83	110		120	110	120		160
Clamping Force		kN(tf)	390(40)			585(60)			735(75)			980(100)				1560(160)				2157(220)
Distance Between Tie Rods　H×V		mm	320×320			375×360			375×360			460×410				560×510				610×560
Clamp Stroke		mm	250			300			300			350				450				520
Open Daylight (Max)		mm	570			670			670			800				950				1090
Machine Dimensions
	LXWXH	m	3.4X1.1X1.6			3.7X1.2X1.6			3.9X1.2 X1.6		4.0X1.2 X1.6	4.2X1.3 X1.7		4.3X1.3 X1.7		5.2X1.5 X1.8		5.3X1.5 X1.8		5.8X1.6 X2.0		5.9X1.6 X2.0

Note)	1.	Due to continuous improvement, specifications are subject to change without notice.
	2.	Max. injection pressure and max. holding pressure are power of injection unit, not resin pressure. They are limited according to molding condition.
	3.	Values marked with* vary with optional High-speed injection unit.
	4.	1MPa=10.2kgf/cm2, 1kN=102kgf, 1mN=0.102gf



	Privacy Policy	Copyright (C) 1997-2005 TOSHIBA MACHINE CO.,LTD. All Rights Reserved.

Caution: Please note that due to the use of javaScript, this page may not be correctly displayed if the browser does not have the required functions or if the settings are not valid.