Product Information

Next-generation Die & Mold function

Flex-drill function (lnclined hole machining)

Flex-drill function (lnclined hole machining)

Inclined holes which are generally processed on a 5-axis machine, can be machined instead on a 3-axis machine with this exceptional tool and feature. The special tool holder and CNC program make it easily possible to machine inclined holes at any angle within a range, and eliminate any costly setup time.

5-axis machining on 3-axis machine !

5-axis machining on 3-axis machine !

Application:

Cooling holes "water lines" on die and mold, and angular pin holes

Holes inclined from 0 to 40 degrees to the vertical plane.
Simple g code command in one block is sufficient to execute the cycle.
G260 X___ Y___ Z___ B___ C___ F___

Sharp inner corner machining function

Sharp inner corner machining function

Square corners in pockets are possible to machine with a special tool.

Machining example at inner corner

Machining example at inner corner

Special tool for machining inner corner

Special tool for machining inner corner

No stock left at inner corner

No stock left at inner corner

Application:

  • Sharp inner corners in pockets
  • Small radius round corner in deep pockets or grooves

Power-flex (High speed head with integrated power generator)

The spindle on the head is directly driven by a motor which is electrically connected to the power generator integrated in the head body without wiring for power supply. The spindle speed on the head is 10 times that of the spindle speed on the basic machine. (Maximum speed is 30,000 min-1)

Power-flex (High speed head with integrated power generator)

The head converts the conventional machine to the high speed machine !!

Power-flex is  a registered trade mark of Toshiba Machine Co., Ltd.

Power-flex is a registered trade mark of Toshiba Machine Co., Ltd.

  • Easy maintenance !
    Spindle unit is a cartridge type that faciliates a replacement if required at maintenance.
  • Spindle is cooled by exhaust  air from the head.
  • No lubrication oil or cooling unit is required.

Wind-Miller (Air drive tool)

Wind-Miller (Air drive tool)

This is an air driven toolholder that is mounted in our ATC magazine, and is supplied with air through the center of the tool for drive power. (Maximum speed is 40,000 min-1)

Wind-Miller with chip blow nozzle

Wind-Miller is registered trade mark of Toshiba Machine Co., Ltd.

Wind-Miller is registered trade mark of Toshiba Machine Co., Ltd.

  • Air driven ! 
    Air drive mechanism for high speed is integrated in the holder
  • Spindle unit is a cartridge type in order to make it easy to replace once at maintenance on the Power-flex.